MEGAPOWER 168 / AD2088 OPERATION AND PROGRAMMING REFERENCE GUIDE (8200-0170-01, REV. A)
17 of 30
Programming Macros
There are eight keys on the AD2088 keyboard used
for macros. A macro can consist of up to 21
keystrokes. Up to a 1000 different macros can be
divided among the eight keys.
Note: Each macro key can have multiple switching
sequences and therefore multiple numbers
associated with the key. The maximum number of
switching sequences that can be assigned to the
eight macro keys = 1000. Numbering for each key
can start at “1”, however, it is not necessary to
assign numbers in exact sequence.
To program a macro:
1. Turn the keyswitch to the PROGRAM position.
2. Enter the macro number (1-1000).
3. Press the macro key to be programmed.
The macro number appears in the CAMERA
display and a keystroke counter starting at 21
appears in the MONITOR/VCR display.
4. Enter the keystrokes that comprise the macro.
As you press keys, the keystroke counter
decreases.
5. When finished entering the macro keystrokes,
press the macro key to save.
IMPORTANT! You must press the same macro
key you selected in step 3 to save the macro.
Resetting the System
WARNING: Resetting the AD168 clears
all programmed information about the
system. Before performing this task,
backup your settings using the S3
software.
To clear all previously programmed information, and
reset the system to its original default settings,
perform a system reset.
1. Turn the keyswitch to the PROGRAM position.
2. Enter 55 and press F2.
3. Enter 99 and press F2.
Note: Step 3 must be performed within 3 seconds of
performing step 2 or the reset will not occur.
Setting the Date Format
Note: This procedure may also be performed
through the menus. See Changing Time and Date
Settings on page 23.
There are three options for the on-screen date
format:
• Month, date year (MM-DD-YY)
• Date, month, year (DD-MM-YY)
• Year month, date (YY-MM-DD)
To set the date format from the keyboard:
1. Turn the keyswitch to the PROG position
2. Enter one of the following F2 code combinations:
• Enter 21, and then press F2 for MM-DD-YY.
• Enter 22, and then press F2 for DD-MM-YY.
• Enter 23, and then press F2 for YY-MM-DD.
• Enter 24, and then press F2 toggles through
the date formats
Note: The default date display format is MM-DD-YY.
Text Display Arrangement
Titles, date, and time can be added to, or removed
from displaying on-screen. The default display
arrangement has titles, date, and time positioned at
the bottom of the screen.
To change the monitor display arrangement:
1. Select the monitor where you want to change the
text display arrangement.
2. Turn the keyswitch to the PROGRAM position.
3. Enter one of the following F2 code combinations.
Table 6: Text Display F2 codes
Code Function
1 - F2
Display the time and date on the monitor.
2 - F2
Remove the time and date display.
3 - F2
Display the camera number, title, and status line
4 - F2
Remove camera title, number, and status line.
5 - F2
Move titles, date, and time to top of display
location.
6 - F2
Move titles, date, and time to home location.
7 - F2
Display all titles, date, and time.
8 - F2
Remove all titles, date, and time displays.
!
To Next Page
Loading...
