American Dynamics AD2088 - Camera Settings Management; Assigning Pseudo Camera Numbers

MEGAPOWER 168 / AD2088 OPERATION AND PROGRAMMING REFERENCE GUIDE (8200-0170-01, REV. A)
26 of 30
Changing Tour Status
The Tour Status setting provides the current tour
operating status for the selected monitor. The
available settings are Hold or Run.
To change the tour status for the monitor:
1. Move the cursor to the Tour Status setting.
2. Press the Enter (Preset) key to change the
setting.
• Select HOLD to pause the tour on the
current camera.
• Select RUN to start the tour.
3. When finished making changes, press Exit
(Patrn) to return to the previous menu.
Configuring the Display of Date and Time
Information
The Date Time setting identifies if date and time
display is enabled for the selected monitor.
To change the date/time display for the monitor:
1. Move the cursor to the Date Time field.
2. Press the Enter (Preset) key to change the
setting.
• Select ON to enable the display of date/time
information.
• Select OFF to disable the display of date/time
information.
3. When finished making changes, press Exit
(Patrn) to return to the previous menu.
Enabling/Disabling the Title Display
The Title Display setting determines if titles are
configured to appear on the selected monitor.
To change the title display for the monitor:
1. Move the cursor to the Title Display setting.
2. Press the Enter (Preset) key to change the
setting.
• Select ON to enable title display.
• Select OFF to disable title display.
3. When finished making changes, press Exit
(Patrn) to return to the previous menu.
Changing Camera Settings
The Cameras menu is used to change settings
associated with pseudo-numbering, video loss
detection, camera titles, and preset titles.
CAMERAS
1. PSEUDO
2. TITLES
3. PRESET TITLES
RETURN MAIN
Use Pseudo to assign pseudo-numbering to the
selected camera.
Use Titles enable video loss detections and assign
a 16-character name to the selected camera.
Use Preset Titles to assign a 16-character name to
presets for a selected camera.
Assigning Pseudo-Numbering to
Cameras
When Pseudo is selected from the Cameras menu,
the following menu displays.
ASSIGN PSEUDO CAMERAS
CAMERAS
REAL # PSEUDO #
0001 0001
0002 0002
0003 0003
0004 0004
PREVIOUS MENU
..
..
0012 0012
Use this menu to assign substitute numbers to
cameras. The “real” camera numbers are based on
video input connection points. The pseudo numbers
permits assignment of any numerical value from 1 to
9999 for any camera input. The Pseudo Number
menu has multiple pages, with 12 camera numbers
appearing on each page. Use the Page Down (Iris
Open) and Page Up (Iris Close) keys to scroll
through the list of cameras.
Note: On a system reset, all pseudo numbers are
reset to the real (default) camera numbers.