DRIVER'S CONTROLS
CRUISE CONTROL OPERATION
NOTE: The cruise control will
not
operate
at
speeds below
approximately
25
mph.
To
set the cruise control:
1)
Press the
ON/OFF
switch
to
apply power to the unit (ignition
switch must be on).
2) Accelerate to the desired speed, push up and release the
SET/
ACCEL
switch. The vehicle will maintain the speed set when
the
SET/ACCEL
switch was released.
3) Hold the
SET/ACCEL
switch up to accelerate. When the
switch is released, the vehicle will maintain the new 'speed.
The cruise control can be disengaged by any
of
the following:
1)
Press the brake pedal. Press the CANCELIRESUME switch
to
resume the previously set speed.
2)
Push down and release the CANCELIRESUME switch. Press
the CANCELIRESUME switch to resume the previously set
speed.- -
3) Press the
ON/OFF
switch.
If
the
ON/OFF
switch is pressed,
the
SET/ACCEL
switch must be
pres~ed
to set a new speed.
,
© 1996
Fleetwood
Enterprises
Inc.
American
Eagle
Wide
Body
ISSUE DATE: 6/96
All
rights
reserved
8
Page 3 of 3
To Next Page
Loading...