American Eagle 1997 - Leveling Procedure

6
Page 20f 5
SEMI-AUTOMATIC
.lEVEIJNG SYSTEM
LEVELING PROCEDURE
Before you operat",'the leveling system, verify the following:
\ -, -
A. The engine is running.
B. The automotive batteries are ON( check the disconnect
switches) and have a minimum charge
oj 1 L volts.
C. The brake system is functioning (at least 90psi on the (lir
pressure gauge) and the PARKING BRAKE is set.
D. The transmission selector is in NEUTRAL.
E. The leveling system is ON.
F. There are no obstructions anywhere under the motor
home.
To level the unit:
I. Press ON/OFF switch on control panel. ON/OFF light
and Electronic LeveLlights will illuminate.
. . - . .
2. Check to see that the exct<ss slope indica,tor is not
flashing.
If excess slope indicator is flashing, move the
motor home toa more level location.
3~ Push and hold~the ALL JACKS DOWN pad until jack
contact with-the
grouIl:d can be feli:. ,
4. Observe the FRON-Tand the REAR Electronic Level
Lights (arrows).
Push and hold the corresponding pad
until the pump
turns.9ff and leveling action stops.
~
5. Observe the LEFT and RIGHT Electronic Level lights
(arrows).
Push and hold the corresponding pad until the
pump turns off and leveling actions stops.
© 1996 Fleetwood Enterprises, Inc.
American Eagle
Wide Body
ISSUE DATE: 6/96 All rights reserved