AMETEK CTS Automotive Transient Immunity Testing
1.00 26 / 26
6. Maintenance, Adjustments, Replacement of Parts
WARNING
WARNING: No user-serviceable parts inside.
Hazardout voltage exist inside the case of the generators. Maintenance must only be
performed by qualified service technicians
The generators do not contain any parts or components requiring special maintenance.
Electrical maintenance must only be performed by experienced and specially trained technicians. Generally,
standard maintenance requires only the periodic cleaning of the instrument, verification and calibration of certain
parameters.
• When removing the cover or other parts of the equipment, high voltage parts may become exposed. High
voltages are potentially lethal.
• For service, repair, adjustment or replacement of parts, the generator must be disconnected from all power
supply sources before covers are to be removed.
• The user is not permitted to change or modify any EM TEST / TESEQ generator. Only original EM TEST /
TESEQ parts and components shall be used for repair and service. AMETEST CTS is not responsible for
accidents or injuries caused through the use of parts or components not sold by AMETEK CTS.
• Maintenance and service must only be performed by qualified service technicians who are trained and
familiar with the dangers of servicing the generator.
• Only fuses of correct voltage and amperage as specified by the manufacturer are to be used for replacement.
The repair of fuses is not permitted.
6.1. Disposal of devices
For the disposal of electronic devices, the country-specific regulations are to be considered. The
equipment should be delivered to a specialized waste collection center.
EM TEST and Teseq devices can be returned to AMETEK CTS in Switzerland or to their agency
for adequate disposal. Alternatively, the equipment can be handed over to a specialized
enterprise for disposal of electronic devices.
Details to used material and components
• Built in capacitors contain no polychlorinated biphenyl (PCB).
• Back-up batteries and rechargeable batteries must be disposed separately.
6.2. Calibration and Verification
Calibration should be performed regularly based on the user’s internal policy. AMETEK CTS recommends
calibration every year.
Verification must be performed, according to the applicatlbe standard, regularly. Consult the applicable standard
for details about regular verification.
For the calibration and verification of the voltage impulses the using of calibration adapters is recommended.
The calibration is at all times without any mains supply on the output to calibrate. Therefore, the following
warnings are to adhere strictly.
To Previous Page
Loading...
Need help?
General
