AMETEK CTS Automotive Transient Immunity Testing
1.00 6 / 26
Only approved accessories, connectors, adapters, etc. are to be used to ensure safe operation.
1.5. Qualification of personnel
The generator must be operated only by authorized and trained specialists with detailed knowledge of the
international, national or manufacturer’s test standard.
1.6. Inspection before Use
1.6.1. Damage due to Shipment
The instrument was tested before shipment and was packed carefully on a transport palette. Each box is marked
with a detailed list of the contents.
Before activating the equipment, check for damage which may have occurred during shipment. Check each
container as well as the generator itself. In case of physical damage, contact the manufacturer before operating
the unit.
Figure 1 - Rack shipment
Figure 2 - System shipment
Figure 3 - Single equipment shipment
1.7. Power requirements
Prior to turning the equipment on, check that the selected voltage corresponds to the supply voltage.
The position of the voltage selector must correspond with the
mains. If you change the mains voltage, replace the fuses
according the recommended value on the number plate.
Figure 4 - Power Requirements
To Next Page
Loading...
