Maintenance | 6-13
Pressure(STCELLP)andtemp
(STCELLT)staticvalueusage.
0=neither, 1=use static pressure,
2=use static temperature, 3= use both
Static cell temperature. Use by
settingSTATICPTto2or3
Static cell pressure. Use by setting
STATICPTto1or3
Referencesoncentrationofthe
reference cell at
Temperature Wavelength resolution
Referencetemperatureforthisdiode
Starting point of concentration window
Endpoint of concentration window
Alphavalueforwirfilter
Beta value for wir filter
Beta value for wir filter
Duty cycle for the sample heater
Power correction Z value 2
Laserpowerofsample channel
Laserpowerreferenceofsample
channel
Laserpowerofsamplechannel2
Laserpowerreferenceofsample
channel 2
For span check - warning limit
For span check - alarm limit
Zerotolerance(ofcalibrange)
Autocalibration.0=disabled,
1=enabled.
0=Zero+Span, 1=Zero, 2=Span
The last day that the calibration was
triggered by the scheduler
1=perform autocal immediately
0=do not adjust auto cal; 1=adjust
auto cal
UserstandarddeviationinWIRfilter
1 = one laser, 2 = two lasers
Boolean,1=ATEX,0=normal
Boolean, 1=present, 0=not present
PRESX1AnalogInputFilteredvalue
Pressure Transducer 1 Scale
PressureTransducer1Offset