6-14 | Model 5100 HD Analyzer
Laserpowerreferenceofsample
channel 2
For span check - warning limit
For span check - alarm limit
Zerotolerance(ofcalibrange)
Autocalibration.0=disabled,
1=enabled.
0=Zero+Span, 1=Zero, 2=Span
The last day that the calibration was
triggered by the scheduler
1=perform autocal immediately
0=do not adjust auto cal; 1=adjust
auto cal
UserstandarddeviationinWIRfilter
1 = one laser, 2 = two lasers
Boolean,1=ATEX,0=normal
Boolean, 1=present, 0=not present
PRESX1AnalogInputFilteredvalue
Pressure Transducer 1 Scale
PressureTransducer1Offset
Boolan: 0 = one cell, 1 = dual cell
Sample spectrum center index
Sample spectrum center index 2
Current offset of pattern
Modulation depth of pattern
Modulation range of pattern
Pattern type, 1=file, 2=generated
Rampscaleofpattern- laser# 2
Current offset of pattern - laser# 2
Modulation depth of pattern - laser# 2
Modulation range of pattern
Pattern type, 0=file, 1=sine, 2=sq
wave
Analyte3(merged)concentration
Cross-overpointforAlyte3
concentration
Analyte3(merged)concentration
Time until next cal cycle
The auto calibration schedule. -1 is
disabled. The time should be a
number like 14:30:45 for 2:30:45 PM.
Next schedule for calibration
Background gas span factor
Background gas mol weight
Background 2 gas span factor
Background 2 gas mol weight
background normal temperature
background normal temperature
To Next Page
Loading...
