Maintenance | 6-19
Analyte3(merged)concentration
Time until next cal cycle
The auto calibration schedule. -1 is disabled.
The time should be a number like 14:30:45 for
Next schedule for calibration
Referenceconcentration of the reference cell
at
ifFALSE,usestaticpressure
Max Pressure allowed in PPMV to Dew Point
Min Pressure allowed in PPMV to Dew Point
Referenceconcentrationalarmband(%)
Referenceconcentrationalarmband2(%)
Background compensation factor
Background compensation temperature
UserAnalogInput1output(engrunits)
UserAnalogInputFixedSubstituteValue
CellRTD1IIRFilterWeight
RTD2(referencecelltemperature)
Unclamped analyte 1 concentration value
Unclamped analyte 2 concentration value
PRESX1AnalogInput Filtered value
ConcentrationofReferencecall
Analyte1Concentrationinotherunit
2nd Concentration Unit of Measure for
analyte 1
Data Valid. 0=Not Valid, 1=Valid
0=Line-lock mode, 1=Sample, 2=Calib
Referencetemperatureforthisdiode
Autocalibration.0=disabled,1=enabled.
0=Zero+Span, 1=Zero, 2=Span
The last day that the calibration was triggered
by the scheduler
1=perform autocal immediately
Analyte3(merged)concentration
Unclamped analyte 1 concentration value
0=do not adjust auto cal; 1=adjust auto cal
UserstandarddeviationinWIRfilter
System state 2. 100=NotReady,
201=MeasureRun,502=Idle,600=diag
Boolean,1=ATEX,0=normal
Analyte3(merged)concentration
Cross-overpointforAlyte3concentration