Ametek 5100 HD - Page 81

User Interface | 4-31
Data Type Description MB Starting
Regs
MB Reg Size
oat Power correction alpha 634 2
int16 Beta value for wir lter 636 1
oat Power correction Z value 637 2
oat Duty cycle for the sample heater 639 2
oat Power correction Z value 2 641 2
oat Laser power of sample channel 643 2
oat Laser power reference of sample channel 645 2
oat Laser power of sample channel 2 647 2
oat Laser power reference of sample channel 2 649 2
oat concentration span 651 2
oat concentration o󰀨set 653 2
oat concentration span 2 655 2
oat concentration o󰀨set 2 657 2
oat span ratio 659 2
oat span ratio 2 661 2
int16 status of span check 663 1
int16 status of span check 664 1
oat zero check 665 2
oat zero check 667 2
int16 status of zero check 669 1
int16 status of zero check 670 1
oat For span check - warning limit 671 2
oat For span check - alarm limit 673 2
oat Zero tolerance (of calib range) 675 2
int16 (NOT USED) 677 1
int16 (NOT USED) 678 1
int16 (NOT USED) 679 1
int16 (NOT USED) 680 1
oat (NOT USED) 681 2
oat (NOT USED) 683 2
oat (NOT USED) 685 2
int16 Auto calibration. 0=disabled, 1=enabled. 687 1
int16 0=Zero+Span, 1=Zero, 2=Span 688 1
int16 The last day that the calibration was triggered
by the scheduler
689 1
int16 Cal period in second 690 1
boolean 1=perform autocal immediately 691 2
oat (NOT USED) 693 2
oat (NOT USED) 695 2
int16 0=do not adjust auto cal; 1=adjust auto cal 697 1
int16 (NOT USED) 698 1
int16 System State (Laser 2). 100=Not Ready,
201=Measure Run, 502=Idle, 600=diag...
699 1