Controller / User Interface | 4-61
Flow Switch Alarm
Allows you to set up the conditions for the Low flow detected
alarm.
Alarm Type Allows you to set the type of alarm that will
be displayed when a flow switching alarm is
detected. Options include:
0 = warning (data is suspect; analyzer re-
quires service)
1 = fault (data is invalid; serious failure
detected; sample system switches to
shut-in/off mode)
Time Delay (sec) The duration (seconds) that the Flow Switch
Alarm will be delayed before it is triggered.
Alarm Type
(Not available for Model 931 or Model 932 Analyzers.)
To Next Page
Loading...
