Specications | 2-17
CSA Certicate and Analyzer Marking
For installation sites that require CSA certification, AMETEK’s CSA cer-
tificate for the Model 931S and Model 932S Analyzers is included in the
following pages.
DQD 507 Rev. 2016-02-18 Page 1
Certificate of Compliance
Certificate: 1031027 Master Contract: 164369 (048179_0_000)
Project: 70097231097231 Date Issued: 2017-02-24
Issued to: Ametek Canada LP
2876 Sunridge Way NE
Process & Analytical Instruments
Division
Calgary, Alberta T1Y 7H9
CANADA
Attention: Allan Delesoy
The products listed below are eligible to bear the CSA Mark shown
with adjacent indicators 'C' and 'US' for Canada and US or with adjacent
indicator 'US' for US only or without either indicator for Canada only.
Issued by:
Bill Bizuk, P.Eng
Bill Bizuk, P.Eng.
PRODUCTS
CLASS - C225802 - PROCESS CONTROL EQUIPMENT-For Hazardous Locations-
CLASS - C225882 - PROCESS CONTROL EQUIPMENT-For Hazardous Locations - Certified to US Standards
For Canada
Class I, Division 1, Groups C and D, Ex d IIB, T3
Optionally: Class I, Division 1, Groups B, C and D, Ex d IIB+H2, T3
Process Analyzer, Model 93X, rated at 104~132 VAC / 208~264 VAC, 3.0 / 2.0 A, <500 Watts, 50/60 Hz,
Operating Temperature Ambient 0
°
C to 50
°
C.
Note:
The Suffix “X” represents option which is application specific to different gases, concentrations and pressures
For USA
Class I, Division 1, Groups C and D, and/or Class I, Zone 1, AEx d IIB, T3
Optionally: Class I, Division 1, Groups B, C and D, and/or Class I, Zone 1, AEx d IIB+H2, T3
To Next Page
Loading...
Need help?
General
