AMETEK CTS AMP 200N series
Manual for Operation V 3.04 59 / 60
14 Appendix
14.1 Declaration of CE-Conformity
Sternenhofstr. 15
CH 4153 Reinach BL1
Switzerland
declares, that under is sole responsibility, the product’s listed below, including all their options, are conformity with the
applicable CE directives listed below using the relevant section of the following EC standards and other normative
documents.
AMP 200N Low frequency signal source DC to 250kHz
AMP 200N1.1 Low frequency signal source DC to 250kHz
AMP 200N2 Low frequency signal source DC to 500kHz
Low Voltage Directive 2014/35/EU
Standard to which conformity is declared:
Safety requirements for electrical equipment for measurement, control, and
laboratory use.
EMC Directive 2014/30/EU
Standard(s) to which conformity is declared:
Electrical equipment for measurement, control and laboratory use
(Requirements for devices to use in industrial area.)
Limits for harmonic current emissions
Limitation of voltage changes, voltage fluctuations and flicker in public low-
voltage supply systems.
The purpose of this instrument is the generation of defined interferences signals for EMI immunity testing.
Depending on the arrangement of the test rig, the configuration, the cabling and the properties of the EUT itself, a
significant amount of electromagnetic radiation may result that could also affect other equipment and systems.
The user himself or herself is ultimately responsible for the correct and controlled operation of the rig. In case of
doubt, the tests should be carried out in a Faraday cage.
A. Burger
Business Manager Conducted EMC
To Next Page
Loading...
