Ametek AMP 200N - AMP 200 N1.1;200 N2 Rear View Connections

AMETEK CTS AMP 200N series
Manual for Operation V 4.0.3 15 / 60
Figure 4
1. TEST ON
2. LED Power
3. LED Fail
4. Measuring input
5. Measuring input enabled
6. 2 wire output indication
7. 2 wire output
8. Coaxial output
9. Coaxial output indication
10. Current clamp input enabled
11. Current clamp input
8 Coaxial output
Output 4N-connector type for the signal from the amplifier. (The 2-wire and coaxial outputs are always in
parallel).
9 Coaxial output indication
LED indication for use the 2-wire output plugs (Flashing).
10 Current clamp input indication
LED indication for the enabled current clamp measurement (Flashing).
11 Current clamp input
BNC input of the frequency selected current clamp measurement.
Input range Max. 10V pk-pk ; Frequency range :10Hz to 250kHz
5.2 Rear view
ATTENTION
Attention: For cooling the AMP200N a minimum free space at the rear of 20cm is requested