Ametek AMP 200N - Covered Standards; Automotive and Other Standards

AMETEK CTS AMP 200N series
Manual for Operation V 4.0.3 8 / 60
2 Standards covered by AMP 200N Series
The AMP 200 is special designed for testing the following standards.
ISO 11452-8
SAE J1113-2
Daimler Chrysler DC 10614-15
Fiat 9.90110 Rev.13 (2007-03)
GMW3097
PSA/Renault EQ/IR 02
VW TL 82566
Mercedes MBN 10284-2
Nissan 28401 NDS 02 Rev.4
GLoyd GL VI-7-2
Automotive
ISO 11452-8
external/internal Magnetic Fields
SAE J1113-2
Voltage Ripple Test, Closed loop / Substitution
Daimler Chrysler DC10614
Magnetic field Rev B
Daimler Chrysler DC11224
Magnetic field
Daimler Chrysler DC10615 Rev D
Supply voltage ripple
Fiat 7_Z0450_2004
Magnetic field
Fiat 9.90110 Rev.13 (2007-03)
Magnetic field
Ford EMC CS 2009 RI140
Coupled Immunity
Ford EMC CS 2009 RI150
Coupled Immunity
Ford EMC CS 2009 CI250
Immunity to Ground Voltage Offset
GMW3097
Magnetic fields
PSA EQ/IR 02
Magnetic fields
Renault EQ/IR 02
Magnetic fields
VW TL 82566
Magnetic fields
MAN M3285
Magnetic fields
Mercedes MBN 10284-2
Magnetic fields
Nissan 28401 NDS 02 Rev.4
Magnetic fields
Volvo STD
Magnetic fields
Other
GLoyd GL VI-7-2
Voltage Ripple test
2.1 General
The AMP 200N series have been designed as a low-frequency signal source to generate sinusoidal signals used
to simulate ripple noise and ground shift noise as required by a variety of standards in the automotive industry
e.g. as per Ford, CI 210 and CI 250 as well as RI 150. The AMP 200N is controlled by the EM TEST Autowave to
also allow the generation of non-sinusoidal and customized signals. Additionally, the AMP 200N can be used to
generate magnetic fields by means of a radiation loop or small Helmholtz coils as per RI 140 of Ford EMC-CS-
2009.1 and Ford FMC 1278.