To Next Page

To Previous Page

MINIFLASH

FP(H) VISION

OPERATION MANUAL

1 GENERAL SAFETY SUMMARY

Review the following safety precautions to avoid injury and prevent damage to this product or any products

connected to it. To avoid potential hazards, use this product only as specified.

Only qualified, service-trained personnel who are aware of the hazards involved should remove the cover from the

instrument.

CAUTION!

If the equipment is used in a manner not specified by the manufacturer, the protection provided

by the equipment may be impaired.

To avoid Fire or Personal Injury:

 Use Proper Power Cord

Use only the power cord specified for this product and certified for the country of use. Avoid bending or

stretching the power cord. Don’t replace the detachable mains supply cord by inadequately rated cords.

 Ground the Product

This product is grounded through the grounding conductor of the power cord. To avoid electric shock, the

grounding conductor must be connected to earth ground.

 Do Not Operate Without Covers

Do not operate this product with covers or panels removed.

 Do Not Operate With Suspected Failures

If you suspect there is damage to this product, have it inspected by qualified service personnel. Do not ignore

warnings on the display or warning signals. Please read the manual or call our representative if you are not

sure what to do.

 Provide Proper Ventilation

Do not cover the ventilation slots. Place the instrument so that proper ventilation is guaranteed.

 Place the instruments so that the main power switch is accessible every time

 Do Not Operate in Wet/Damp Conditions

To avoid electric shock, do not operate this product in wet or damp conditions.

 Do Not Operate in an Explosive Atmosphere

To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.

 Keep Product Surfaces Clean and Dry

 Operate with proper protective Clothing (goggles, gloves, lab coat)

 Be careful with flammable liquids

Flammable liquids should only be used by qualified employees. These substances should be used with

constant regard to the danger they pose to life and property. Under normal circumstances they should

always be used in a fume-hood away from possible sources of ignition. For further information read the

safety data sheet of the substance.

Ametek MiniFlash FP Vision User Manual

Questions and Answers: