AMETEK CTS VDS 200Q Series
Manual for Operation V 1.3.1 28 / 36
U = to 80 V ± 2% ± 50 mV with 0.1 V steps setting
Output resolution Front panel setting
Output resolution AutoWave setting
AutoWave ADC 16 Bit: Resolution < 1 mV
Current VDS 200Q200.2
VDS 200Q150.2
VDS 200Q100.2
VDS 200Q50.2
VDS 200Q25.2
I = 0 A – ± 200 A ± 5% (600 A for 200 ms)
I = 0 A – ± 150 A ± 5% (450 A for 200 ms)
I = 0 A – ± 100 A ± 5% (300 A for 200 ms)
I = 0 A – ± 50 A ± 5% (150 A for 200 ms)
I = 0 A – ± 25 A ± 5% (75 A for 200 ms)
Bandwidth (-3dB)
Rise Time
Independent of programmed voltage and voltage range.
DC-250 kHz
Typ. <3us (High Freq.), <10 us (Standard)
Zi = < 10 m, 10 m - 200 m in 10 m steps ± 2% ± 5 mΩ
Zi = Ri (DC ... 400 Hz)
t
rec
= 90 % of max. excursion within 25 μs
U
r
= < 0.2 V peak to peak
as per test routines
5.1.1.Sense
Settling Time
Accuracy
Max Correction
4 µs/V
±5% of the necessary correction
8V
Auto release with preselected parameters
Manual release of a single event
External release by external trigger
Safety laboratory connectors at front panel
High current connectors at rear panel
Safety laboratory connectors at rear panel
-10 to +10 V / 10k / DC – 250 kHz
5 – 15 V TTL signal (BNC connector)
5 V TTL signal (BNC connector)
Baudrate: Setting; 1,200 to 19,200 Baud