Ametek VDS 200Q Series User Manual

AMETEK CTS VDS 200Q Series
Manual for Operation V 1.3.1 30 / 36
6.
Maintenance
6.1.
General
The generator contains no user-serviceable parts inside.
6.2.
Test set-up
When setting up the test national and international regulations regarding human safety have to be guaranteed.
The test setup must conform to the national and international regulations.
The generators of the series 200, UCS, LD, PFM, VDS and AutoWave, can be linked together to a fully
automotive test set-up.
The set-up communicates via the IEEE/GPIB bus and is controlled by ISM ISO software. For setting up the
system see the following figures:
Each generator can be operated individual as single equipment.
6.3.
Test set-up with software iso.control
By using iso.control software:
• Connect the VDS 200Q to a computer running iso.control via GPIB or USB
By using autowave.control software
• Connect the VDS 200Q to a computer running autowave.control via GIPB or USB

Ametek VDS 200Q Series Specifications

General

Brand	Ametek
Model	VDS 200Q Series
Category	Amplifier
Language	English