Ammann ARR 1575 Yanmar - Check of the Near and Remote Halt Function

107ARR1575
-
+
!
hours
555126
6
557024
4
555077A
MAINTENANCE MANUAL
3.6.9. Check of the near and remote halt
function
• Turn the key to the II position (preheating). The engine must
not be started.
The III position (start) must not be activated.
• Gradually move closer with the infrared remote control to a
distance of less than 2 metres to the rear part, front part and
side part of the machine from the infrared sensor and each
time move the control stick of the left/right steering angle
(4) to the right.
• The LED safety bar indicator (6) on the display unit must al-
ways light up.
If the infrared remote control is not functional or the sa-
fety bar indicator on the display unit does not light up,
it is forbidden to operate the machine until the fault is
removed.
In order to use the infrared remote control properly, fo-
llow the instructions given in Chapter 2.6.2.3.