Ammann ARR 1575 Yanmar - Machine Control and Use; Commissioning

59ARR1575
2.7. Machine control and use
2.7.1. Commissioning
Before putting the machine into operation, always read the operating manual and inspect the machine according to
the instructions below.
Inspection of the machine before putting into operation:
• check, if the arm securing the joint during machine transport or loading is unlocked
• check the battery status of the infrared remote control
• check the automatic pairing function of the infrared remote control and the control unit
• check the workplace with regards to the prevention of interference of the electronic ballast (caused by external xtures tted with
uorescent tubes)
• check the near and remote machine halt function
• check the safety bar function (optional equipment)
• check the tightness of the fuel tank and fuel system
• check the tightness of the hydraulic circuit
• check the tightness of all screw connections
Note:
If the infrared remote control does not work and all LED indicators are o, connect the transmitter to the machine via the spiral cable.
The battery will recharge.