Ammann ARR 1575 Yanmar - Display Unit and Indicators

41ARR1575
-
+
!
hours
555012
1 2
3
4
5
6
7
OPERATION MANUAL
2.6.1. Display unit
Operating hours counter (1)
RAM02
-
+
Control lamp for battery charge level (charge
control) (2)
The pilot lamp lights up after the key in the switch box is swit-
ched in position „I“ and goes out after the engine starts. If the
pilot lamp lights up during operation or does not go o after
starting, carry out the following check immediately.
• Stop the engine.
• Check the engine for defective or loose V-belt.
If the battery charging lamp is still on after you have carried out
this check, contact Ammann authorized service.
RAM01
!
Control lamp functions (3)
The Error control lamp lights as soon as the controller recogni-
zes an error.
The tilt sensor is activated. The compactor is in position with the
angle exceeding 45°. Put the machine into vertical position.
Electric installation fault. Check the electric installation for short
circuit or broken cable.
If the fault lamp is still on after you have carried out this check,
contact Ammann authorized service.