Ammann ARR 1575 Yanmar - Page 53

47ARR1575
555014
OPERATION MANUAL
2.6.2.1. LED signals
• There are two LED signals on the transmitter: green and red.
There are two LEDs on the cover: a green one and a red one.
Standard display (green)
Display Cause
The green LED is blinking slowly. The machine is controlled by the infrared remote control and cable
The green LED is ashing. The machine is controlled by the infrared remote control
Battery charge status indicator (red).
The red LED indicator ashes faster or slower depending on the battery charge status.
The more the battery is discharged, the slower the red LED indicator ashes.
When the battery is discharged, the red LED indicator lights continuously.
Controlling via the infrared remote control
Display Cause Remedy
Red LED signal ashing. Battery almost at. Connect the charging cable for at least 1 h.
Red LED signal lit. Battery at, remote control out of operation. Connect the charging cable for at least 1 h.
Controlling via the infrared remote control and cable
Display Cause Remedy
The red LED ashes. The battery is being charged.
The red LED is lit. The battery is fully charged.
Note:
When the battery is discharged, it is still possible to control the machine using the infrared remote control and cable.
Battery warnings and errors are only displayed during active control (i.e., when a control element is actuated).
When disconnecting the cable from the infrared remote control, the red LED indicator lights up for about 1 second.