H-1.601.00149-2.0
Page
36
battery that is fully charged, battery can be replaced directly during
operation.
2. Press the battery button and take the battery out of the gap.
Fig. 39 Remove battery
3. Install the fully charged E6 battery, load it in the direction shown in the
figure, press it after loading, you can hear the click of the battery button
reset, and make sure the battery is installed.
Fig. 40 Battery install
4. If only one battery is left in the device and the external power is not
connected, you need to “stop” the device and restart according to
steps 2 and 3.
5.7.2 Connect with external power
You can connect the E6 power supply under all E6 operating modes.
Use the power cord:
• Connect the power cord to the E6.
• Connect the power cord to a wall outlet (100-240V, 50/60 Hz)
Use the vehicle charging cord:
To Next Page
Loading...
