Amoul E6 - Sanitary Treatment; General Cleaning Procedures; Removing and Installing Suction Cup

H-1.601.00149-2.0
Page
41
6 Sanitary treatment
After each use of the E6 chest compression system, do the following:
1) Replace the suction cup (see section 6.2);
2) If necessary, perform a general cleaning procedure (see section 6.1).
6.1 General cleaning procedures
Clean all surfaces and belts with a soft cloth and warm water containing a
mild detergent or disinfectant. The cleaner or disinfectant can be:
• 70% isopropyl alcohol solution
• 45% isopropyl alcohol with added detergent
• Quaternary ammonium compounds
• 10% bleach
Follow the instructions provided by the disinfectant manufacturer.
Note：
Do not immerse the E6 in a liquid. If liquid enters the hood, it will cause
damage to the equipment. Allow the E6 to dry before wrapping it.
6.2 Removing and installing the suction cup
Pull the suction cup down,Dispose it as contaminated medical waste,Install a
new suction cup.
Note：
Make sure the suction cup is securely connected.