2.
Always make back-up (duplicate) copies of discs which contain valuable
programs.
It
is especially important to make back-up copies ofthe master
CP/M
system discs provided with
the
6128. Should you otHerwise accidentally lose or
corrupt your discs, replacing them could prove expensive.
3.
Make sure
that
you
do
not accidentally overwrite your master
CP/M
system
discs, by ensuring
that
the
Write Protect holes on the discs are always open.
4.
If
you are operating a 2-drive system, i.e.
if
you have purchased
an
additional
AMSTRAD FD1, always switch on
the
2nd disc drive before switching on the
computer.
5.
Never touch
the
floppy disc surface itself, inside its protective casing.
6.
Do
not eject a disc while
it
is being read from or written to.
7.
Always remember
that
formatting a disc will erase any previous contents.
8.
The
internal
disc interface occupies a small portion ofthe memory
that
in
some
cases, was used by commercial writers of cassette based software for the
AMSTRAD model CPC464. These cassettes will not operate properly with the
6128
+ Cassette unit.
If
you have any queries regarding cassette based software
compatibility, contact
AMSOFT on Brentwood (0277) 230222. Note however,
that
most major AMSOFT software titles are available on disc
for
the
6128.
9.
The licence agreement for your
CP/M
system discs, (which are electronically
serial-number encoded) permit their use on a single computer system only. In
particular this means
that
you are prohibited from giving any other person a
_<!isc
with YOUR serial-numbered
copy
of
CP/M
on it. Carefully read
the
End
User
Program Licence Agreement
TAppenaixl)~-towards-tlie
endoCthis··
-
manual.
CPC
6128
Warnings
To Next Page
Loading...
