IMPORTANT
You
must read this
....
Installation Notes
1.
Always connect the Mains Lead to a 3-pin plug following the instructions
contained in
part
1 of the Foundation course.
2.
Never
attempt
to
connect the system to any Mains Supply other
than
220-240V
~
50Hz.
3.
There
are
no
user serviceable
parts
inside the system.
Do
not attempt to gain
access into the equipment. Refer all servicing
to
qualified service personnel.
4.
To
avoid eye-strain, the monitor should be placed as far away as possible from
the
keyboard and operated in
an
adequately
lit
room. The monitor
BRIGHTNESS control should be kept to as Iowa setting as possible.
5.
The computer should be placed centrally in front of the monitor,
but
as far away
from the screen as possible. For maximum data reliability, the disc drive section
of
the
computer should NOT be placed directly in front
ofthe
monitor,
but
to
the
right
of it.
Do
not place
the
computer close to any source of electrical
interference.
6.
Always keep disc dri ves and discs away from magnetic fields.
7.
If
you
are
operating a 2-drive system, keep the interconnecting ribbon cable to
the
2nd drive, away from Mains Leads.
8.
Do
not block or cover any ventila tion holes.
9.
Do
not use or store
the
equipment
in
excessively hot, cold, damp, or dusty areas.
Operation Notes
(Don't worry
if
you are a little baffled by the technical jargon
in
this section; the
importance of these warnings will become clearer as you work through this manual.)
1.
Never switch the system on or off with a disc
in
the drive. Doing
so
will corrupt
your disc, losing valuable programs or data.
Warnings
CPC
6128
To Next Page
Loading...
