When
the
disc
that
you wish to copy from is
in
the
drive, press the Y key,
(Y
is for Yes,
meaning 'go-ahead
and
copy
the
disc').
The format of
the
disc will be examined by
the
computer, and displayed
at
the
top of
the screen for your information.
After a while, you will see the message:
Insert
disc
to
WRITE
Press
any key
to
continue
At
this
point, you should
take
the
disc
that
you are copying out of the drive. Then
insert
the
disc for copying onto, and press any key.
Information about
the
format of
the
disc to be copied onto (even
if
it
is a new
unformatted disc) will be indicated
at
the
top of the screen.
If
the
disc
that
you wish to copy onto is not correctly formatted (or not formatted
at
all),
this
will be
taken
care of
during
copying, and you will see a message such as:
Disc
isn't
formatted
(or
faulty)
Goi
ng
to
format
whi
le
copyi
ng
Di
sc
wi
II
be
system
format
....
or some other similar message, depending upon the discs
that
you are copying
between.
When
the
computer is
again
ready for the disc to copy from,
it
will display the
. .
message:
Insert
disc
to
READ
Press
any key
to
continue
....
and you should re-insert
the
disc to copy from.
After
repeating
this
process a few times, the contents of the first disc will be copied
onto
the
second disc, and the message:
Copy
completed
Remove
disc
Press
any key
to
continue
.... will appear, whereupon you should follow
the
instructions on the screen, which
give you
the
option to
either
copy another disc (by typing
Y)
or 'exit'ing to
the
main
DISC
KIT
menu.
Foundation Course'
Chapter 1 Page
79
To Next Page
Loading...
