Battery Life and Replacement
168
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
2. Make sure to seat fully the battery plug to the connector in the device (FIG. 124). If fingers cannot be used, use a
clean, nonconductive stick or probe to seat the connectors.
3. Reattach the back of the device, engaging the ledge at the bottom of the device and using it to swing the back down
into place.
4. Insert the seven screws and replace the rubber feet atop the two upper screws, using the replacement rubber feet
included in the Battery Pack Kit. Replace the bottom label over the three bottom screws, using the replacement label
included in the Battery Pack Kit (FIG. 125).
5. Slide the IR emitter cover back into place over the emitter until it clicks.
6. Restart the device to confirm that the new battery is functioning correctly.
When reassembling the device, take especial care not to pinch or squeeze the
connector wiring or the battery. Do not force the back cover onto the device, as this
can damage the device.
FIG. 125 Rear of the MVP-9000i-WH
IR Emitter Cover
Rubber feet
Position of replacement label
Please dispose of the old battery in a proper fashion as required by municipal or
federal regulations.
To Next Page
Loading...
Need help?
General
