Upgrading Firmware
99
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
A Special Note for Network Interface Connections
Due to any USB connection to your PC being made through a Network Interface Connection (NIC), Windows will
automatically make any new NIC connection the Primary connection. If this happens, the USB address of 12.0.0.x will
show up across the PC’s network switches as the PC’s source address. In some cases, network administrators will notice
the NIC connection and reconfigure any PC that has connected to the MVP-9000i. Business, college, and government
installations are the type of installations that would be most affected, and most home installations would not be affected.
To prevent the NIC connection from becoming the primary connection:
1. From the Windows Start menu, select Settings > Control Panel to open the Control Panel window.
2. In the Control Panel window, click on the Network Connections icon to open the Network Connections window
(FIG. 112)
3. From the Advanced menu, select Advanced Settings... to open the Advanced Settings window (FIG. 113).
4. Under the Adapters And Bindings tab, the user needs to make sure the Local Area Connection is not at the top of the
Connections list. If it is at the top of the list (FIG. 113), select it and use the down arrow to the right of the list to
move it to the bottom of the list (FIG. 114).
FIG. 112 Network Connections window
FIG. 113 Advanced Settings window
To Next Page
Loading...
Need help?
General
