ES
FR
DE
GB
IT
C13961962IDM
English
-
19
-
Use and installation manual
Caution - warning
Whenever the cooking mode is changed, clean
the chamber thoroughly.
To carry out this operation, proceed as follows.
1–In STOP status press button (20) (icon (16) lit with
a green light).
The display (7) shows the message "CLE", the dis-
play (8) the message "Pr" and the display (9) the
message "P01".
2–When the beeper sounds (about 8 min. after
washing starts) and the "CLE" message flashes on
the display, place the detergent in the cooking cham-
ber.
3–Open the door and spray the food-approved de-
tergent onto all the walls of the cooking chamber, the
heat exchanger and the fan.
Use of the "cleaner spray" accessory and the de-
tergent provided by the manufacturer is recommended for this procedure.
Caution - warning
When cleaning and sanitising the appliance with detergents, wear personal pro-
tection equipment (gloves, masks, goggles, etc.) as required by the relevant
health and safety legislation.
4–Close the door and wait for the oven to complete the washing, rinsing and final
thermal disinfection program automatically. A beeper sounds at the end of the wash-
ing cycle.
Important
Before cooking again, check that no detergent residues have been left in the
cooking chamber. If residues are found, rinse the cooking chamber thoroughly
by hand and heat the oven in "convection" mode for about 15 min. to dry it out.
To carry out this operation, proceed as follows.
1–Clean and drain the condensation collection channel (A).
2–Clean the condensation collection tank (B) and check that the drain hole and line
are not blocked.
WASHING LEVEL 2 APPLIANCE
CLEANING THE CONDENSATION COLLECTION CHANNEL AND TANK
IDM-39619500100.tif
20
16
9
7
8
IDM-39617700600.tif
B
A
To Next Page
Loading...
Need help?
General
