ES
FR
DE
GB
IT
C13961962IDM
English
-
20
-
Use and installation manual
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction
of any anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical
knowledge or skill is required, and so they must only be carried out by qualified staff
with recognised experience acquired in the specific sector of operation.
Fault
Cause
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identify
the alarm signals which appear on the display (7).
Important
Press button (12) to reset the alarm and the cook-
ing cycle restarts automatically; if this is not the
case, press the start key (16).
FAULT
6
TROUBLESHOOTING
Fault Cause Remedy
The appliance does not
switch on
Fuse "blown" Replace the fuse (see page 30)
Electronic circuit board damaged Contact the after-sales service
Cooking cycle does not start
or stops suddenly
Control board electronic circuit board
damaged
Contact the after-sales service
Alarm triggered Consult the "Key to Alarms" table
Safety or protection device (safety
thermostat or overload cutout)
tripped
Consult the "Key to Alarms" table +
Press device reset button
TABLE OF ALARM INDICATIONS
IDM-39619500100.tif
12
16
7
To Next Page
Loading...
Need help?
General