25
EverTrack
TM
Mode – F 02 (Continued)
4. Move each machine axis to the part zero position.
5. Press
This will be the absolute part zero position.
NOTE: You can also preset dimensions as long as the DRO is in Absolute Mode. The
zero position corresponding to the stored preset dimensions will be stored and
can be recalled using EverTrack
TM
Mode.
To exit EverTrack
TM
Mode:
6. Press
7. Press
The RI turns off and the DRO stores the absolute part zero position.
8. Continue with normal operations.
Recalling a Part Zero Position
To recall a part zero position activate the RI as follows:
One Axis
1. Press
to select the feature.
Press the desired axis key.
Press
The axis display resets to zero and the RI begins to blink.
To Next Page
Loading...