5
First-Time User Checklist
Your new DRO has many preset values. Before you proceed, please review the
following list to verify default settings. If you need to change any setting(s), refer to
Parameter Settings – F 20
.
Description of Setting Factory Setting Your Setting
1. Mill/Lathe Operation MILL
2. Linear Encoder Resolution Axis 1 5 µm
Axis 2
5 µm
3. Direction of Count Axis 1
+
Axis 2
+
4. Position Tolerance Indicator Axis 1 Set to Zero
Axis 2 Set to Zero
5. Audible Keyboard Tone ON
6. Display Resolution Axis 1 .0002 inches (.005mm)
Axis 2
.0002 inches (.005mm)
7. Display Dimming 15 Minutes
8. Radius Diameter Mode Axis 1 Radius
Axis 2 Radius
To Next Page
Loading...