Anritsu ML2400A Series - Page 179

MOF Set the off set value at the spec i fied mem ory lo ca tion in
dBm.
Syn tax: MOF<mem><;><value>
mem: Mem ory lo ca tion 1 to 30.
value: Off set value in dBm.
Re marks: Set the off set value at mem ory store ad dress <mem> to <value> dBm
MRF Set the ref er ence value at the spec i fied mem ory lo ca tion
in dBm.
Syn tax: MRF<mem><;><value>
mem: Mem ory lo ca tion 1 to 30.
value: Ref er ence value in dBm.
Re marks: Set the ref er ence value at mem ory store ad dress <mem> to <value>
dBm.
ODT Out put the cur rent cal i bra tion fac tor, off set value, and
ref er ence level.
Re marks: These are out put as three sep a rate mes sages in the out put buffer, as
shown be low:
CAL fac tor: 18 ASCII char ac ters + <CR><LF>
OFF SET value: 18 ASCII char ac ters + <CR><LF>
REF ER ENCE level: 19 ASCII char ac ters + <CR><LF>
NOTE
When the ODT, OMR, and OPW data out put com mands
are re ceived si mul ta neously, only the com mand which is
re ceived last is valid.
6-92 ML2400A OM
ML4803A EMULATION COMMANDS GPIB OPERATION
Fig ure 6-3. ODT Data Out put Format