Anritsu ML2400A Series - C-4 TRIGGER MENU

C-4 TRIGGER MENU The Trig ger menus are al ways avail able in PROFILE op er a tion mode, as se -
lected from the Sys tem menu. In READOUT and POWER vs. TIME modes,
the trig ger setup menus are avail able if a sen sor used on a dis play chan nel has
its
SENSOR|Setup|MODE set to CUSTOM . In READOUT mode, the trig ger
setup menus are avail able if the mode is set to Int A, Int B (ML2408A only),
EXTTTL, Man ual or Con tin u ous. In CDMA Read out mode, de fault trig ger set -
tings are used and can not be changed.
Trig ger } only avail able if a sen sor used on a dis play
} chan nel is in “cus tom mea sure ment mode” and
} sys tem setup mode = READ OUT or Power
} vs. TIME; or if sys tem setup mode =
} PRO FILE; or link read out/pro file trig ger = ON
} chan nels only avail able if ON
Setup
[TRGMODE ] CHAN NEL } only avail able if sys tem setup mode = Read out or
} Power vs. Time, both with “link trig gers” OFF
1 | 2 | 1&2
[TRGSRC, GTSRC ] SOURCE } int B not avail able in ML2407A
Con tin u ous | int A | int B | EXT TTL | man ual
[TRGDLY, GTDLY ] Sam ple DE LAY
0 to 1 sec ond
[TRGGW, GTGW ] Sam ple gate WIDTH
100ns to 7 sec onds
[TRGARM, GTARM ] Trig ger ARMING } if SOURCE = con tin u ous or in ter nal A
} or in ter nal B on ML2408A, or man ual
Blanking ON | blank ing OFF
[TRGTYP, GTTYP ] Trig ger TYPE and level menu } if source = in ter nal A or in ter nal B on
ML2408A
Trig ger TYPE
Rise | fall
[TRGLVL, GTLVL ] Trig ger LEVEL
-30 dB to +20 dB
[TRGXTTL, GTXTTL ] Trig ger EDGE } if source = EXT TTL
Rise | fall
Trig 1 } if trig chan 1 = man ual
Trig 2 } if trig chan 2 = man ual
Trig 1&2 } if trig chan 1&2 = man ual
C-8 ML2400A OM
TRIGGER MENU APPENDIX C