Anritsu ML2400A Series - System Defaults

A-3 SYSTEM DEFAULTS The fol low ing de fault pa rame ters are loaded when ever pre set is se -
lected from the front panel or through GPIB.
SYSTEM DEFAULTS APPENDIX A
A-6 ML2400A OM
SEN SOR - setup
set tle % per read ing 0.10%
meas ure ment mode de fault
range hold auto
SEN SOR - cal fac tor
Source Fre quency
source ( HP 437B & HP 438A ) man ual
source = fre quency
in put sig nal fre quency 50 MHz
source = man ual
cal fac tor 100%
cal ad just 100%
in put sig nal fre quency 50 MHz
source = volts/GHz
start freq 10 MHz
stop freq 20 GHz
start volt age 0 volts
stop volt age 10 volts
units per cent
SEN SOR - av er ag ing
SYS TEM - setup = read out or power vs. time
Read out MODE STANDARD
mode auto
mode ( HP 437B & HP 438A ) auto
mode = mov ing
mode = re peat
av er ag ing number 64
auto low level av er ag ing low
SYS TEM - setup = pro file
graph av er ag ing state off
be tween cur sor av er age on
SEN SOR - off set
off set type off
off set type ( HP 437B ) off
off set type ( HP 438A ) fixed
off set type = fixed
off set value 0 dB