Mne monic Ac tion Sup ported? Re stric tions
LM1 Limit check on Yes Both high and low on as HP 437B
LN Units to Watts Yes None
LP Learn mode1 No Not supported
LT Left arrow No Not supported
MZ Terminator Yes None
OC0 RF cali bra tor off Yes None
OC1 RF cali bra tor on Yes None
OD Ou put dis play text Yes Sup ports read ing out put and Cal fac tor
ta ble out put only (F=Fac tory ta ble).
OF0 Off set off Yes None
OF1 Off set on Yes None
OS Set off set value Yes OS DOEN not supported
PCT Terminator Yes None
PR Preset Yes None
RA Auto range Yes None
RC Re call setup Yes Lim ited to 10 stores
RE Resloution Yes Set screen deci mal places
RF0-RF9 Sen sor cal factors Yes None
RH Range hold Yes None
RL0 Rela tive mode off Yes None
RL1 New rela tive value Yes None
RL2 Use old rela tive value Yes None
RM Set sen sor range Yes ML2400A ranges
*RST Reset Yes None
RT Right arrow No Not supported
RV Read SRE Yes None
SE Se lect data table Yes None
SM Status ouput Yes As much as has mean ing for ML2400A.
Set to 0 if not used
SN0-SN9 Se rial number Yes None
SP Special No Not supported
*SRE Set SRQ enables Yes None
*SRE? Read SRQ enables Yes None
ST Store setup Yes Lim ited to 10 stores
*STB? Read status byte Yes None
TR0 GPIB trig ger hold Yes None
TR1 Im me di ate trigger Yes None
TR2 Set tled trigger Yes None
TR3 Trig ger hold off Yes None
*TST? Selftest Yes Al ways re turns 0
UP Up arrow No Not supported
@1 Status mask Yes None
@2 Learn mode 2 No Not supported
% Terminator Yes None
HP 438A Com mands
Mne monic Ac tion Sup ported? Re stric tionsMne monic Ac tion Sup ported? Re stric tions
ML2400A OM B-17
APPENDIX B HP-IB SUPPORT
To Next Page
Loading...
