Anritsu ML2400A Series - Page 258

Fre quency | man ual | vghz
SETUP } if source = VGHz only
[CVSTF ] START Freq
10kHz to 122GHz
[CVSPF ] STOP Freq
10kHz to 122GHz
[CVSTV ] START Volts
-0.5V to 20.5V
[CVSPV ] STOP Volts
-0.5V to 20.5V
[CFFRQ ] In put sig nal FREQuency } if source = FREQ or MAN UAL
10kHz to 122GHz
[CFUSL, CFUTBL, ] USE TA BLE } if source = VGHz or FREQ
[CFUUSE, CFUVLD ]
Fac tory | 1 to max ta bles | fac tory + “1 to max ta bles”
max ta bles = 10 but de ter mined by space in sen sor EEPROM
[CFUNITS ] %/dB
[CFUADD, CFULD, ] EDIT ta ble } if source = VGHz or FREQ
[CFURD ]
TA BLE
1 to max ta bles
EDIT val ues
down
up
CHANGE
FREQuency
10kHz to 122GHz
de ter mined by fit ted sen sor
FACTOR
150% to 0.07%
–1.76dB to 31.55dB
DONE
IN SERT
FREQuency
10kHz to 122GHz
de ter mined by fit ted sen sor
C-2 ML2400A OM
SENSOR MENU APPENDIX C