Frequency Converter Interface (Option 6)
Introduction
Option 6 provides added circuitry and a connector to provide power, control signals and a
local oscillator signal to a frequency converter.
The Anritsu FCN4760 4.7 GHz to 6.0 GHz Frequency Converter can be used with this op
-
tion. When the frequency converter is attached to the Site Master, the frequency range of
the combination becomes 4.7 GHz to 6.0 GHz.
NOTE: The frequency converter interface (Option 6) and the FCN4760 fre
-
quency converter apply to Spectrum Analyzer mode only.
5-7
Chapter 5 Spectrum Analyzer Measurements
To Next Page
Loading...