Anrtisu Site Master S331D - Chapter 12 - GPS Feature

Chapter 12
GPS Feature
Introduction
The S331D/S332D Site Master is available with a built-in GPS receiver feature (Option 31)
that can provide latitude, longitude and altitude information and UTC timing. The following
GPS antennas and accessories are available from Anritsu:
·
2000-1410 Magnet Mount GPS Antenna with 15-foot cable
Activating the GPS Feature
To activate the GPS feature:
Step 1. Install the Anritsu GPS antenna to the GPS antenna connection on the Site Mas
-
ter connector panel.
NOTE: The GPS antenna connection on the Site Master is fitted with a reverse
BNC connector to help prevent damage to the GPS circuitry. There is a DC
voltage present on this connector. Do not connect anything other than the
Anritsu GPS antenna to this port.
Step 2.
Press the SYS key.
Step 3. Select the
GPS soft key.
Step 4. Press the
GPS On/Off soft key to turn the GPS feature on or off. When GPS is
first turned on, the GPS icon below will be displayed in red:
When the GPS receiver has tracked at least three satellites, the GPS icon will
change to:
Step 5. Press the
Location soft key to view the latitude, longitude and altitude informa
-
tion and UTC timing.
Step 6. Press the Quality soft key to display the number of tracked satellites and the GPS
quality.
NOTE: Press the Reset soft key to reset the GPS.
12-1
GPS
GPS