Table of Contents
Chapter 1 - General Information
Introduction ..................................1-1
Description ...................................1-1
Standard Accessories .............................1-1
Options .....................................1-2
Printers .....................................1-3
External Detectors ...............................1-3
Optional Accessories..............................1-4
Performance Specifications ..........................1-6
Preventive Maintenance ...........................1-12
Calibration ..................................1-12
InstaCal Module ..............................1-13
Annual Verification..............................1-13
ESD Precautions ...............................1-13
Mode References ...............................1-13
Chapter 2 - Functions and Operations
Introduction ..................................2-1
Test Connector Panel .............................2-1
Display Overview ...............................2-3
Front Panel Overview .............................2-4
Function Hard Keys ..............................2-5
Keypad Hard Keys ...............................2-6
Soft Keys....................................2-8
Power Monitor, External Detector (Option 5) ................2-38
Transmission Measurement (Option 21) ...................2-39
Interference Analyzer Mode (Option 25)...................2-46
Channel Scanner Mode (Option 27) .....................2-55
CW Signal Generator Mode (Option 28) ...................2-58
Power Meter Menus (Option 29) .......................2-61
T1 Tester Mode Menus (Option 50) .....................2-63
E1 Tester Mode Menus (Option 50) .....................2-66
Symbols....................................2-68
Self Test ...................................2-69
Error Messages ................................2-70
Battery Information..............................2-75
Charging a New Battery ..........................2-75
Determining Remaining Battery Life....................2-76
Important Battery Information .......................2-79
Chapter 3 - Getting Started
Introduction ..................................3-1
Power On Procedure .............................3-1
Cable and Antenna Analyzer Mode ......................3-2
Spectrum Analyzer Mode ..........................3-11
All Modes...................................3-15
Save and Recall a Setup ..........................3-15
Save and Recall a Display .........................3-15
i