Anrtisu Site Master S331D - Function Hard Keys; Dynamic Attenuation Control; BERT Measurement Setup; Signal ID

Changing the Units .............................3-16
Changing the Language...........................3-16
Adjusting Markers .............................3-16
Adjusting Limits ..............................3-17
Adjusting the Display Brightness......................3-18
Printing ....................................3-19
Using the Soft Carrying Case.........................3-20
Chapter 4 - Cable and Antenna Analyzer Measurements
Introduction ..................................4-1
Line Sweep Fundamentals ...........................4-1
CW Mode/RF Immunity ...........................4-2
Information Required for a Line Sweep ...................4-3
Typical Line Sweep Test Procedures ....................4-3
Chapter 5 - Spectrum Analyzer Measurements
Introduction ..................................5-1
Measurement Fundamentals ..........................5-1
Preamplifier ..................................5-3
Preamplifier Operation............................5-3
Preamplifier Measurement Example.....................5-4
Dynamic Attenuation Control .........................5-6
Frequency Converter Interface (Option 6)...................5-7
Introduction .................................5-7
Selecting the Signal Standard and Channel ..................5-8
Field Strength Measurements ........................5-9
Occupied Bandwidth .............................5-10
Channel Power Measurement........................5-12
Adjacent Channel Power Ratio .......................5-14
Interference Analysis .............................5-16
AM/FM Demodulation ............................5-17
Demodulation Procedure ..........................5-17
Carrier to Interference Ratio (C/I) ......................5-19
Procedure ..................................5-19
Chapter 6 - Internal Power Meter Mode
Introduction ..................................6-1
Power Measurement ..............................6-1
Offset Calibration ..............................6-2
Chapter 7 - Power Monitor Mode
Introduction ..................................7-1
Power Measurement ..............................7-1
Chapter 8 - High Accuracy Power Meter
Introduction ..................................8-1
Power Measurement ..............................8-2
ii