Anrtisu Site Master S331D - Page 44

q
Center Freq - Activates the center frequency function and sets the Site
Master to the center frequency. A specific center frequency can be en
-
tered using the keypad or Up/Down arrow key.
q
Int BW — Enter the integration bandwidth frequency appropriate for
the application. Integration bandwidth must be at least one tenth of the
channel span.
q
Channel Span — Sets the channel span to a value appropriate for the
application.
q
Zoom One Channel — Automatically sets the span to cover one chan
-
nel as defined by the selected signal standard.
q
Measure — Enables and disables the channel power measurement.
q
Back — Returns to the previous menu level.
q
ACPR — Accesses a menu of Adjacent Channel Power Ratio measure
-
ment options:
q
Center Freq - Activates the center frequency function and sets the Site
Master to the center frequency. A specific center frequency can be en
-
tered using the keypad or Up/Down arrow key.
q
Main Channel BW - Sets the bandwidth of the main channel.
q
Adjacent Channel BW - Sets the bandwidth of the adjacent channel.
q
Channel Spacing - Sets the channel spacing.
q
Measure -Enables and disables the ACPR measurement.
q
Back - Returns to the previous menu.
q
More — Opens more measurement menus in spectrum analyzer mode.
q
Int. Analysis — Opens the interference analysis measurement menu.
q
Set IA Freq. — Set the interference analysis frequency from 9 kHz
to 3000 MHz to measure the interference.
q
Measure — Measures the interference.
q
IA Freq. To Center — Set the interference analysis frequency to
the center of the interference frequency.
q
IA Freq as Marker M1 — Set the interference analysis frequency as
marker M1.
q
Back — Returns to the previous menu.
q
AM/FM Demod — Select AM, Narrow Band FM (300 ms de-empha
-
sis), Wide Band FM (50 ms de-emphasis), USB or LSB.
q
On/Off — Turns AM/FM Demodulation on or off.
q
Demod Type — Select either AM, FM Wide Band, FM Narrow
Band
, SSB Lower or SSB Upper demodulation.
q
Demod Freq — Use the Up/Down arrow key or the keypad to in
-
crease or decrease the demodulation frequency. Select the
GHz,
MHz, kHz,orHz soft key to accept the frequency input.
q
Volume — The current volume setting is displayed at the lower
right of the screen. Use the Up/Down arrow key to increase or de
-
crease the volume, and press the ENTER key to select.
q
Demod Time — Use the Up/Down arrow key or the keypad to in
-
crease or decrease the demodulation time, and press the ENTER
key to select.
q
Back — Returns to the previous menu.
Chapter 2 Functions and Operations
2-23