Anrtisu Site Master S331D - Page 50

SYS
In cable and antenna analyzer or optional power meter mode, pressing the SYS
key displays the following System menu soft key selections:
q
System Options — Displays a second level of system option functions:
q
Clock — Displays a second level of functions:
q
Hour — Enter the hour (0-23) using the Up/Down arrow key or the
keypad. Press ENTER when data entry is complete or ESCAPE to
restore the previous value.
q
Minute — Enter the minute (0-59) using the Up/Down arrow key or
the keypad. Press ENTER when data entry is complete or ESCAPE
to restore the previous value.
q
Month — Enter the month (1-12) using the Up/Down arrow key or the
keypad. Press ENTER when data entry is complete or ESCAPE to
restore the previous value.
q
Day — Enter the day using the Up/Down arrow key or the keypad.
Press ENTER when data entry is complete or ESCAPE to restore the
previous value.
q
Year — Enter the year (2003-2036) using the Up/Down arrow key or
the keypad. Press ENTER when data entry is complete or ESCAPE
to restore the previous value.
q
Back — Returns to the top-level SYS menu.
q
Printer — Displays a menu of supported printers. Use the Up/Down arrow
key and ENTER key to make the selection.
q
Units — Select the unit of measurement (metric or English).
q
Change Date Format — Toggles the date format between
MM/DD/YYYY, DD/MM/YYYY, and YYYY/MM/DD.
q
Back — Returns to the top-level SYS menu.
q
Application Options — Application options displays options applicable to par-
ticular mode.
q
CAL Mode — In cable and antenna analyzer modes, selects either OSL
Cal or FlexCalä. FlexCal is a broadband frequency calibration valid from
25 MHz to 4 GHz. Refer to Calibration, page 3-2, for more information.
q
Back — Returns to the top-level SYS menu.
q
Self Test — Start an instrument self test.
q
Status — In cable and antenna analyzer freq or dist measurement mode, dis
-
plays the current instrument status, including calibration status, temperature,
and battery charge state. Press ESCAPE to return to operation.
q
GPS — Opens the GPS soft key menu.
q
Press the GPS On/Off soft key to turn the GPS feature on or off.
q
Press the Location soft key to view the latitude, longitude and altitude in
-
formation and UTC timing.
q
Press the Quality soft key to display the number of tracked satellites and
the GPS quality.
q
Press the Reset soft key to reset the GPS.
q
Back — Returns to the previous menu.
q
Language — Pressing this soft key immediately changes the language used to
display messages on the Site Master status window. Choices are English,
Chapter 2 Functions and Operations
2-29