Anrtisu Site Master S331D - Page 56

q
Printer — Displays a menu of supported printers. Use the Up/Down arrow
key and ENTER key to make the selection.
q
Units — Select the unit of measurement (metric or English).
q
Change Date Format — Toggles the date format between
MM/DD/YYYY, DD/MM/YYYY, and YYYY/MM/DD.
q
Back — Returns to the top-level SYS menu.
q
Application Options — Application options displays options applicable to par
-
ticular mode.
q
External Ref Freq — Set the external reference frequency from 2 MHz to
20 MHz.
q
Bias Tee — Selects Bias Tee on or off.
q
Impedance — Sets the input impedance of the instrument
q
50W — Sets the input impedance of the instrument to 50W, which is
the default setting.
q
75W Anritsu 12N50-75B — Displays measurements as if the input
impedance was 75W. The actual input impedance is still 50W, but the
displayed information is transformed to the equivalent 75W value
based on the offset value specified by the adapter used in the measure
-
ment. This setting is commonly used for cable TV-related measure-
ments. Pressing this soft key will also compensate 7.5 dB for the loss
of the Anritsu 12N50-75B adapter.
q
Other adapter Offset — This key allows the user to enter other adapter
offset values. Enter the desired loss using the keypad or Up/Down ar-
row key and press the ENTER key to accept.
q
Back — Returns to the previous menu.
q
Back — Returns to the top-level SYS menu.
q
Self Test — Start an instrument self test.
q
Status — In cable and antenna analyzer freq or dist measurement mode, dis-
plays the current instrument status, including calibration status, temperature,
and battery charge state. Press ESCAPE to return to operation.
q
GPS — Opens the GPS soft key menu.
q
Press the GPS On/Off soft key to turn the GPS feature on or off.
q
Press the Location soft key to view the latitude, longitude and altitude in
-
formation and UTC timing.
q
Press the Quality soft key to display the number of tracked satellites and
the GPS quality.
q
Press the Reset soft key to reset the GPS.
q
Back — Returns to the previous menu.
q
Language — Pressing this soft key immediately changes the language used to
display messages on the Site Master status window. Choices are English,
French, German, Spanish, Chinese, and Japanese. The default language is
English.
Chapter 2 Functions and Operations
2-35