q
Segment 1-5 — View/edit lower limit segment 1-5.
q
On/Off — Turns the segment on or off.
q
Edit — Opens the segment parameters for editing (see Adjusting Seg
-
mented Limits, page 3-17).
q
Prev Segment — Edit or view the parameters of the previous segment.
q
Next Segment — Edit or view the parameters of the next segment. If
the next segment is off when this button is pressed, the starting point
of the next segment will be set equal to the ending point of the current
segment (if the current segment is on).
q
Back — Returns to the previous menu level
q
Back — Returns to the previous menu level.
q
Limit Beep — Turns the audible limit beep indicator on or off. When the
limit beep indicator is on, an audible beep will occur at every data point that
appears above the upper limit or below the lower limit.
MARKER
Pressing MARKER on the data keypad in Transmission Measurement mode ac
-
tivates a menu for the six different markers. Use the corresponding soft key to
select the desired marker. Then use the marker second level menu to turn the
markers on or off, and to edit marker parameters and values.
q
M1 — Selects the M1 marker parameter and opens the Markers second level
menu with M1 highlighted.
q
On/Off — Turns the selected marker on or off.
q
Edit — Opens the selected marker parameter for data entry. Enter the de-
sired marker frequency using the keypad or Up/Down arrow key. Select
the
GHz, MHz, kHz,orHz soft key to accept the marker frequency input.
q
Delta (Mx-M1) — Displays delta frequency and amplitude for the selected
marker Mx (M2, M3 or M4) with respect to the M1 marker.
q
Marker To Peak — Places the selected marker at the maximum amplitude
of a trace (M1 - M4 only).
q
Marker Freq To Center — Makes the center frequency equal to the fre
-
quency of the selected marker.
q
Back — Returns to the previous menu level.
NOTE: The markers second-level menu above is identical for markers M2-M4.
q
M2 — Selects the M2 marker parameter and opens the Markers second level
menu with M2 highlighted.
q
M3 — Selects the M3 marker parameter and opens the Markers second level
menu with M3 highlighted.
q
M4 — Selects the M4 marker parameter and opens the Markers second level
menu with M4 highlighted.
q
All Off — Turns off all markers.
q
More — Press to access additional marker functions:
q
M5 — Selects the M5 marker parameter and opens the M5 marker second
level menu with M5 highlighted.
2-44
Chapter 2 Functions and Operations
To Next Page
Loading...