Anton Sprint Pro - Charger and Interface Specifications; Pressure and Temperature Specifications

28
Specification Sprint Pro
Pressure Measurements
Measurement • Draught Pressure
• Differential pressure
• Operating pressure
• Working pressure
• Let-by/Tightness Test
Test and report/print structure for combined test
suitable for use to IGEM/11/UP/1B.
Differential Range 0 – 400 mbar
Resolution 0.01 mbar
Accuracy +/-0.5 mbar or 1% of reading
Selectable Units Pa, hPa, kPa, PSI, inWG, mmWG, inHG, mmHG
Temperature Measurements
Differential Temperature
measurement
(flow and return)
K-Type Thermocouple Measurement Range: -50°C
to 1000°C
Accuracy: ±2°C or 1.5% of reading
Charger
Charging Temp Range 0°C – 40°C
Charger Input USB-C
Required Charger
Specification
• USB A Output
• UK Pin Type
• DC output voltage: +5V +/- 0.25V
• Minimum output current: 1A
• Output Power: 5W
• AC Input voltage: 90-264VAC, 50/60Hz
• Operating Temperature 0 to 40 degrees C
• Load Regulation: +/-5%
• Ripple & noise: 300mV p-p
• Protection: Over Current, Over Voltage, Short Circuit
• Certifications:
o CE Mark
o Designed to meet EN55022
o ErP Level VI
o RoHS
Interfaces
IR Port Report printing to IR printer.
USB-C Charging & and PC connection.
Mobile apps Supports use with Android and IOS apps
Implements a dual mode device supporting
Basic Rate (BR), Enhance Data Rate (EDR) & Low
Energy (LE).