5
Sprint Pro Sprint Pro Orientation
Charging battery
It is recommended that Sprint Pro is fully charged before first use.
Note: Sprint Pro’s battery must not be charged at temperatures below 0°C or above 40 °C.
1. Plug the USB charger into a mains socket.
2. Connect the charger to the Sprint Pro using the USB-C connector on
the unit.
3. Switch on the power at the mains socket.
4. Sprint Pro would normally be left switched off for charging. The
display will show the battery charging icon during charging. The
battery will recharge in three hours from flat and when fully charged
the battery icon will turn green in colour.
Please see specification in section VII for Sprint Pro run times. A shorter charge
time can be applied, such as 1/2 hour, though it will give limited length of
operation from that charge.
Low battery
When the battery is low, Sprint Pro will display a low battery icon. If the battery
gets too low, then Sprint Pro will give further warning before switching off.
Use of the charger as a power adaptor
The Sprint Pro charger can be used to power the unit and will continue to
charge whilst operating Sprint Pro.
Automatic battery saver
If Sprint Pro is not undertaking a test it will automatically power down if left
unused. Sprint Pro will warn user when power down is imminent.
Sprint Pro has a lithium-ion rechargeable battery.
Batteries are non-replaceable by the user and must only be replaced by author-
ised service centres.
Warning: Only use USB chargers provided with Sprint Pro and standard USB-C
charger leads.
USB C
To Next Page
Loading...
Need help?
General
