Anviz CX7 User Manual

CX7
Touchless Face Recognition
Time Clock
User Guide
Rev: 06/2022

Anviz CX7 Specifications

General

Model	Anviz CX7
Identification Mode	Fingerprint, Card, Password
Logs Capacity	100, 000
Event Log Capacity	100, 000
Relay Output	1
Alarm Output	1
Exit Button	Yes
Power Supply	12V DC
Humidity	20% to 80%
Wiegand Signal	Wiegand 26/34
Access Control Type	IP Access Control
CPU	32-bit
Fingerprint Sensor	Optical
Communication	TCP/IP, RS485
Sensor	Optical
Display	LCD
Verification Speed	< 1 second

Summary

Step 1 Create CrossChex Cloud Account

Step 2 Activate your CX7 Time Clock

Network Setup by Cable (LAN)

Configure wired network connection for the time clock using Ethernet.

Wireless Network Setup (WiFi)

Connect the time clock to a wireless network by selecting SSID and entering password.

Cloud Setup

Configure the terminal to connect to the CrossChex Cloud account.

Step 3 Add Department

Step 4 Device Management

Step 5 Add Employee

Punch Management

Select employee verification modes (Fingerprint, Face, Password, Card) for clocking.

Role Settings

Assign roles (Employee, System Admin, Custom Role) and set login access for employees.

Scheduled Settings

Assign working shifts and schedule days off for employees.

Step 6 Device Wall Mount

Installation Position

Recommended horizontal and vertical distances for optimal face recognition.

Terminal Installation

Steps to mount the device on a wall using the backplate and screws.

Step 7 CX7 Introduction

Step 8 Device Operation

Network Settings - Ethernet

Network Settings - WiFi

Network Settings - Internet

Network Settings - Cloud

T&A (Time and Attendance Settings)

Access (Access Control Settings)

Test & Update

Warranty and Disclaimer

Dead on Arrival ("DOA")

Policy for product defects occurring immediately after shipment and compensation.

Hardware Safety Instructions

Guidelines for safe operation and preventing injury or property damage.