9
6.12 MEM~STORE:
Short press: use memory channel
1.Short press
key to choose programmed function group.
2.Short press the programmable key which allocated as MEM function to enter memory
channel, turn channel switch to choose memory channels.
3.Short press it again to store setting and exit.
Long press: Memory channel store position
1.Choose a channel
2.Short press
key to choose programmed function group.
3.Long press the programmable key which allocated as MEM function , the LCD displays
memory channel number, turn channel switch to choose channel number(CH-01~CH-08),
Long press [MEM] key until LCD displays the stored channel.
»
1.when the channel number is not flash, means the channel already stored into
memory channel.
»
2.when the channel number is flash, means the channel is not into memory
channel.
»
This function is valid only when the CALL set with valid DTMF group. refer page 14
or page 15 of Call setting for details.
6.13 DW: Dual-watch control
1.Choose rst dual-watch channel,,and select working mode(AM or FM)
2.Short press key to choose programmed function group.
3.Short press the programmable key which allocated as DW function, LCD ashes and
displays "D".
4.Turn channel knob to choose second dual-watch channel, short oress other self-dene
key to set working mode(AM or FM)
5.Short press allocated the programmable key again to turn on DW fuction, LCD displays
"D".
6.Press [PUSH] key or key to exit dual-watch function.
6.14 CAL: transmit DTMF code
1.Short press key to choose programmed function group.
2.Short press the programmable key to transmit DTMF code which allocated as CAL
function.
6.15 NB: NB function
1.Short press key to choose programmed function group.
2.Short press the programmable key which allocated as NB function, LCD displays
NB:XX.
3.Short press it again or turn channel switch to NB function between ON-OFF.
4.Press [PUSH] key or key to store setting and exit.
To Next Page
Loading...
Need help?
General
